Help
Links
Here you can find setup information for your chosen VPN and also how to fix any problems you might encounter.
You can use the Table of Contents on the right hand side of this window to navigate between the different sections.
Step 1
Go to Administration, then Commands
Step 2
Enter which openvpn in the box
Step 3
Click the Execute command button
Step 4
Verify that you receive a path for OpenVPN, such as /usr/sbin/openvpn
Step 5
If you do not receive a path for OpenVPN your current firmware does not have OpenVPN included, you need to upgrade to either the VPN or Mega DD-WRT firmware, if the device flash etc allows. Please consult the DD-WRT website for further information.
Step 1
Download the OpenVPN script you wish to use, we would recommend you first install OpenVPN on a computer to determine the connection that is best for you to use. Please note, these scripts require a current version of DD-WRT with OpenVPN 2.4, if you're running on older release please email us for compatible scripts.
Step 2
Retrieve the Server Address for the VPN you want to connect to, you will need this later:
Step 3
Retrieve your VPN username and password, if you are a new member this is contained in the StreamVia Account Information email you received after ordering.
Step 1
Please factory reset DD-WRT first, this is strongly recommended to prevent any potential conflicts
Step 2
Connect the DD-WRT WAN port to the LAN port on your existing broadband router/modem
Step 3
Configure the router as you would normally, WPA/WEP keys for wireless etc
Step 4
Ensure you can browse the internet normally, via the DD-WRT router, if not please troubleshoot this first
Step 5
Setup → Basic, for Static DNS 1 and 2 enter the following, 8.8.8.8 and 8.8.4.4
Step 1
Administration → Commands
Step 2
Enter the below and click 'Save Firewall'
iptables -t nat -I POSTROUTING -o tun0 -j MASQUERADE iptables -A FORWARD -p tcp --tcp-flags SYN,RST SYN -j TCPMSS --clamp-mss-to-pmtu iptables -I PREROUTING -t nat -p udp --dport 53 -j DNAT --to-destination 1.1.1.1 iptables -I PREROUTING -t nat -p tcp --dport 53 -j DNAT --to-destination 1.1.1.1
Step 1
Open the StreamVia DD-WRT OpenVPN script that you wish to use in notepad, fairly near the top edit USERNAME and PASSWORD replacing with your VPN username and password, ensure there are no white spaces on the ends of lines etc.
Step 2
Edit SERVER_ADDRESS in the same script and replace with the address of the server you wish to use, REMOTE must stay at the beginning.
Step 3
Copy the entire script from notepad and copy to the clipboard
Step 4
Paste into Administration → Commands
Step 5
Click 'Save start up'
Step 1
Reboot the router
Step 2
It may take 1-2 minutes to complete after reboot, the script waits 60 seconds after boot for attempting to connect to let things settle.